Copyright © Convertible Percussions. All rights reserved. 2015
Copyright © Convertible Percussions. All rights reserved. 2015

Special Note:
Adjust retrigger sensitivity/threshold on your control module to get your desired e-drum performance.

 2 easy ways of switching between Electronic and Acoustic kit
1.  Once mesh head is installed on one side and acoustic head is installed on other side,
     just flip drum over.
2.  Remove mesh head, lower trigger  ½” below bearing rim, tighten 2 trigger support
​     nuts and reinstall your original acoustic drum head.

Up Mount

Down Mount

TB-8  e-drum Trigger Installation Instructions
(Single or dual zone trigger)

Lug hardware dimensioning and shell sizes vary from kit to kit. The TB-8 was designed to accommodate most, if not all configurations and sizes.  The TB-8 can be mounted up or down using any of the 4 hole positions on the TB-8  bracket.  Performance will not be effected.    Only 1 screw is required, the natural drum shell curvature locks the TB-8 into place once tightened.

Use Up Mount  when hardware lugs are between 3-6” from bearing edge


Use Down Mount  when hardware lugs are between 1-3.7” from bearing edge

" Hover " for pull down menus

edrums, trigger, percussion, etrigger, e-trigger,  drums, electronic drums, diy drum triggers, conversion kit, acoustic to electronic drum conversion kit, replacement triggers, foam cone, cone trigger, foam drum trigger.